Bundt Cake - 1:12 Silicone Mould
This silicone mould can be used to make a miniature Gugelhupf in two sizes.
The 1:12 cake has a diameter of approx. 17.7 mm. The cake marked 1:12+ is a little larger - if you want to vary a little with the sizes or your doll's house sometimes needs slightly larger non-scale parts. 1:12+ corresponds to a diameter of approx. 21.2 mm.
The mould is heat resistant up to 200° C for a short time. Material like polymer clay can therefore be baked in the mould (110° C for 30 minutes).
Epoxy resin can also be used as a filling, but this significantly reduces the life of the mould, as the resin causes it to become brittle over time. UV resins are not suitable, as the mould should be transparent.
Instructions
Press a small ball of polymer or air dry clay into the moulds (I use modelling tools for this).
Bend the mould to release the clay and bake your miniatures in a preheated oven according to the manufacturer's instructions (do not exceed 200° C!). Alternatively, you can leave the chocolates in the mould and only remove them after baking.
Content
You'll get one slilicone mould.
Measurements
- Mould: 54x42x11mm
- 1:12 Bundt Cake: ∅ ~17,7mm
- 1:12+ Bundt Cake: ∅ ~21,2mm
Notice
- The silicone is not food safe.
- These silicone moulds are not toys, but collectors' items for adults, so they are not suitable for children!
- Each silicone mould is unique, so there may be minimal variations.
- All other items shown are not part of this offer.
| Material: | Silicone |
|---|---|
| Scale: | 1/12 / One-inch |
complementary Miniatures
